Instructions

How to Make a C&C Cage

Connect all the grids together to form you cage
We are showing a 3 x 2 cage
Measure the area you want to fit your correx into.
Lets just say on this 3 x 2 cage the area size would be 142cm x 76cm.
     
Now add the size of the lip to your area, in this instance we have added a lip of 11cm so the area total need to be increased by 22cm (as the lip is on all sides ), this now makes our correx size 164cm x 98cm


     
Now mark out your correx
     
The main white area on this image shows the base of the correx and the coloured in red area shows the lip
                  
     
Score along all the lines we show in blue, the cat along the lines we have shown in green

     
You should now have something like this
     
Bend the corners around and either tape or use rivets

              
     
Put the correx inside you cage and you are ready for your piggies !!
 
Tools you will need

Scissors or a Stanley knife.
Pen or Magic Marker
Tape measure or Ruler
Ruler or straight edge for marking
Clear packing tape or rivets
 
     
Optional
 
  Make a hay feeder from 1 sheet
Get 1 extra sheet and bend it around a piece of wood.
 



                  
  Make a hole in a sheet for the ramp (pliers required)
Make a standard roof
This example shows a 3 x 2 roof made from 8 panels, all panels are cable tied together.
The roof is hinged by cable ties at the back of the cage.
Make a folding roof
This example shows the use of a metal bar along the middle of the roof panels allowing the roof panel to fold, as the
bar is a little longer than the width of the cage it also acts as a support for the roof.
Support Bar
Can be used for roof support or loft support




 
Powered By OpenCart
Mesh Cube (Grendle Enterprises) © 2017